6: History; View Events - Honeywell FIRE-LITE MS-10UD Series Manual

Master Programming Level
Pressing 1 while viewing Onboard DACT Screen #2 will cause the following screens to appear:
Ring Count
SERVICE TERMINAL
1=RING COUNT
Service Terminal Screen #2
A flashing cursor will appear in the lower left corner of the display. Enter the two-digit ring count which can be a value
between 00 and 25. After the second digit is entered, the display will return to the Service Terminal screen.
Supervised Phone Line

The Supervised Phone Line feature allows the user to disable the supervision of Phone Line 2 by the DACT when using an alternate
means of secondary transmission path. The factory default setting is Phone Line 2 supervised.
DACT
1=SERVICE TERMINAL
2=SUPERV PHONE LINE
Onboard DACT Screen #2
Each press of the 1 key while viewing this screen will toggle the option between Supervise Phone Line 2 Yes and No.
3.5.6 History
PROGRAMMING
1=SYSTEM SETUP
2=OPTION MODULES
3=HISTORY
Programming Screen #2

View Events

HISTORY
1=VIEW EVENTS
2=ERASE HISTORY
History Screen
While displaying the View Events screen, press 1 to view all events, 2 to view only alarms, or 3 to view other events. Use the up and
down arrow keys to scroll through all of the displayed events.
MS-5UD & MS-10UD Series Manual — P/N 52626:C7 6/12/2018
SERVICE TERMINAL
1=RING COUNT
Service Terminal Screen
The ring count designates the number of rings allowed on the phone line prior to answering an incoming
call from a service terminal. The factory default is 0 which means the control panel will not answer an
incoming call. This entry may be programmed for 1 to 25 rings.
To change the Ring Count, press 1 while viewing the Service Terminal Screen #2. The following screen
will be displayed:
RING COUNT
RANGE 00-25 RINGS
Ring Count Screen
Pressing 2 for Superv Phone Line while viewing Onboard DACT Screen 2 will cause the following screen
to be displayed:
SUPERVISE PHONE LINE
1=PHONE LINE 2
The History option allows an authorized user to view or erase events which have occurred in the control
panel. Pressing 3 while viewing Programming Screen #2 will display the History options as shown in the
following display:
HISTORY
1=VIEW EVENTS
2=ERASE HISTORY
History Screen
Pressing 1 while viewing the History Screen will allow the user to select the events to be viewed as illus-
trated in the following:
HISTORY
1=VIEW ALL
2=VIEW ALARMS
3=VIEW OTHER EVENTS
View Events Screen
0
YES
Programming
91