Display Messages - Yamaha 01V Owner's Manual

258
Appendix A: General

Display Messages

BULK: Byte Count Mismatch!
BULK: Check Sum Error!
BULK: Memory Protected!
DIGITAL IN Sync Error!
For Effect2 Only.
LOW BATTERY!!
Memory Protected
MIDI IN: Framing Error!
MIDI IN: Data Overrun!
MIDI: Rx Buffer Full!
MIDI: Tx Buffer Full!
NO DATA
Now Fading(Fade Time).
OPTION IN Sync Error!
Read Only
Selected channel: CHxx
Preparing to LOCAL OFF...
TO HOST: Framing Error!
TO HOST: Data Overrun!
TO HOST: Data Parity Error!
TO HOST: Rx Buffer Full!
TO HOST: Tx Buffer Full!
WRONG WORD CLOCK!
01V—Owner's Manual
Message Meaning
The byte count of the received Bulk Dump data is not cor-
rect.
The check sum of the received Bulk Dump data is not cor-
rect.
The Bulk Dump data cannot be stored because the desti-
nation is write-protected.
This warning message appears if the Digital Stereo Coaxial
In signal is not wordclock synchronized with the 01V.
Make sure that all digital equipment is wordclock synchro-
nized to a common wordclock source. See "Setting the
Wordclock" on page 209 for more information. This warn-
ing message can be disabled by turning off the DIGITAL IN
SYNC CAUTION option in the preferences ("Setting 01V
Preferences" on page 203).
The selected effect program can be recalled only to
Effect 2.
The internal battery voltage is getting very low. Back up
the Setup data ("Bulk Dump" on page 232), and ask your
dealer to replace the battery.
Cannot execute as selected scene memory is protected.
An incorrect signal may have been input to the MIDI IN.
An incorrect signal may have been input to the MIDI IN.
The 01V is probably receiving too much MIDI data.
The 01V is probably transmitting too much MIDI data.
Cannot execute as no data has been stored.
Local Control cannot be turned off while a mix-scene fade
is in progress (Fade Time).
This warning message appears if the Option I/O input dig-
ital signal is not wordclock synchronized with the 01V.
Make sure that all digital equipment is wordclock synchro-
nized to a common wordclock source. See "Setting the
Wordclock" on page 209 for more information. This warn-
ing message can be disabled by turning off the DIGITAL IN
SYNC CAUTION option in the preferences ("Setting 01V
Preferences" on page 203).
Cannot execute as selected scene memory is read only.
CHxx is the selected channel.
The MIDI Local Control function is preparing for use.
An incorrect signal may have been input to the TO HOST
connector.
An incorrect signal may have been input to the TO HOST
connector.
An incorrect signal may have been input to the TO HOST
connector.
The 01V is probably receiving too much MIDI data at the
TO HOST connector.
The 01V is probably transmitting too much MIDI data
from the TO HOST connector.
The received wordclock is not correct and the 01V cannot
synchronize correctly. Select a suitable wordclock, or use
the AUTO NAVIGATE function on the SETUP page 1.