Main Stereo Meters; Peak Hold - Yamaha 01V Owner's Manual

84
Chapter 7—Solo, Monitors & Meters
Omni Outs
HOME page 3 displays signal level meters for the four omni outs. The source assigned
to an omni out is displayed below its meters. These assignments are made on
PAN/ROUT page 4. See "Assigning Omni Outs" on page 116 for more information.
Stereo Output
HOME page 4 displays signal level meters for the stereo output. Compared to the main
stereo meters, these have a large scale from –72 dB to CLIP.
Meters for the stereo output also appear on the VIEW pages. See "Viewing Stereo Out-
put Settings" on page 89 for more information.

Main Stereo Meters

L STEREO R

Peak Hold

The Peak Hold function works with the HOME, OPTION I/O, and main stereo meters.
When it's turned on, the meter segments lit by the loudest signal peaks remain on, pro-
viding an easy way to check for peak levels.
1. Use the PARAMETER wheel, [–1/DEC] and [+1/INC] buttons, or [ENTER]
button to turn the Peak Hold function on or off.
To reset the Peak Hold function, turn it off and then on again.
01V—Owner's Manual
In addition to the meters on HOME page 4, stereo output levels are
displayed on the dedicated 12-segment main stereo meters, with
CLIP
Peak Hold. The meters range from –48 dB to CLIP. If a CLIP LED
–3
does light, reduce the stereo output level to prevent signal distor-
–6
–9
tion. The main stereo meters are not affected by the metering
–12
points on HOME page 5.
–15
–18
–24
–30
–36
–42
–48