Midi Machine Control - Yamaha 01V Owner's Manual

236
Chapter 17—MIDI

MIDI Machine Control

Using MIDI Machine Control (MMC) commands, an MMC-compatible recorder can
be controlled from the 01V. [ON] buttons 1 through 6 can be used to control transport
functions, while [SEL] buttons 1 through 6 can be used to locate six definable locate
points. MMC commands are transmitted via MIDI.
1. Use the [REMOTE] button to locate REMOTE page 2, as shown below.
While this page is displayed, controls other than [ON] buttons 1 through 6 and [SEL]
buttons 1 through 6 are disabled.
2. Use the cursor buttons to select the DEVICE No. parameter, and the
PARAMETER wheel or [–1/DEC] and [+1/INC] buttons to select a device
number.
The device number, which can be set from 1 through 127 or ALL, should be set to
match that of the recorder you want to control. When set to ALL, all MMC-compatible
recorders connected can be controlled together.
3. Use [ON] buttons 1 through 6 to transmit the following transport com-
mands to a recorder.
4. Use the cursor buttons and PARAMETER wheel or [–1/DEC] and [+1/INC]
buttons to set the locate times in hours, minutes, seconds, and frames.
5. Use [SEL] buttons 1 through 6 to transmit the locate commands to the
recorder.
Locate points can be stored using MIDI Bulk Dump. See "Bulk Dump" on page 232 for
more information.
01V—Owner's Manual
On Button
1
2
3
4
5
6
Function
Rewind
Fast Forward
Stop
Play
Pause
Record
MMC Command Value
05
04
01
02
09
06