Display Messages - Yamaha 01X Software Installation Manual

Can't find the mLAN Stream Driver.
Re-install the mLAN Drivers.
Can't find the 01X on the mLAN network.
Make sure that the 01X is turned on and that the mLAN cable connection is correct and secure. After that, restart "mLAN Auto
Connector for 01X".
The settings of the mLAN Driver could not be changed.
1) If an application that uses the driver is currently active, close it first, then change the settings.
2) There is not enough resource memory.
Failed to set the 01X's wordclock to slave.
Set the master clock of the 01X so that mLAN Auto W.CLK is set to "ENABLE."
1) Press the [UTILITY] button on the 01X.
2) Select "W.CLK" (press knob 3) on the 01X.
3) Set the parameter to "ENABLE"
Failed to initialize the mLAN settings because the application "mLAN Start" is not running.
Select "ON" from the menu of "mLAN Manager" application.
Can't connect the 01X's mLAN audio output plug to the computer's mLAN audio input plug.
Can't connect the 01X's mLAN MIDI output plug to the computer's mLAN MIDI input plug.
Can't connect the computer's mLAN MIDI output plug to the 01X's mLAN MIDI input plug.
Can't connect the computer's mLAN wordclock output plug to the 01X's mLAN wordclock input plug.
Can't connect the 01X's mLAN wordclock output plug to the computer's mLAN wordclock input plug.
A new 1394 adaptor card has been found.
If you've inserted a new card, restart the computer.
There is not enough resource memory.
Execute mLAN Stop, then execute mLAN Start again. If this fails, restart the computer.
The 1394 adaptor card has not been found.
Check the card and start mLAN again.
One of the programs could not be started. Follow the instructions/messages in the appropriate application. If there are no
messages, execute mLAN Start again or restart the computer.
The application is not responding.
Execute mLAN Start again or restart the computer.
Failed to load the mLAN Bus Driver.
If the New Hardware Wizard has not been run, use it to install the hardware, then execute mLAN Start.
One or more programs could not be closed.
After quitting all DAW programs and any programs using mLAN, execute mLAN Stop.

Display Messages

Messages
TOOLS for 01X/Plug-in Effect Installation Guide
Page
6, 18
9, 20
12
9, 20
10
9, 10
9, 10
9, 10
9, 10
9, 10
10
32
10
10
10
10
29