Table of Contents
Advertisement
6.2.2 Configuring Intrusion Detection
Intrusion detection can set an area in the surveillance scene and once the area is entered, a set of alarm
action is triggered.
Steps:
1. Enter the intrusion detection interface:
Configuration > Events > Smart Event >Intrusion Detection
2. Check the Enable checkbox.
3. The event triggered and park action related PTZ movement will be locked for 180 seconds after you
enter the intrusion detection interface. Optionally, you can click the
manually activate the movement, or lock the movement when the button turns to
by clicking it.
4. Draw area.
(1) Select the Region No.in dropdown list.
(2) Click
(3) Click on the image to specify a corner of the rectangle, and right-click the mouse after four
corners are configured.
5. Configure the parameters for each defense region separately.
Threshold: Range [0-10s], the threshold for the time of the object loitering in the region. If you
set the value as 0, alarm is triggered immediately after the object entering the region.
Sensitivity: Range [1-100]. The value of the sensitivity defines the size of the object which can
trigger the alarm, when the sensitivity is high, a very small object can trigger the alarm.
Detection Target: Set the detection target. You can select human, vehicle, or all (human
&vehicle) as the detection target from the dropdown list. For example, if Human is selected,
only human beings will be identified as detection objects.
6. Click
User Manual of PanoVu Series Network Camera
Configuring Intrusion Area
Figure 6-13
to draw a rectangle on the image as a defense region.
tab to enter the arming schedule setting interface. The time schedule
80
button to
Advertisement
Table of Contents
