HIKVISION DS-2DP1618ZIXS-DE User Manual page 30

E-mail Encryption: Email encryption can be selected among None, SSL, and TLS. When you select
SSL or TLS and disable STARTTLS, e-mails will be sent after encrypted by SSL or TLS. The SMTP port
should be set as 465 for this encryption method. When you select SSL or TLS and enable STARTTLS,
emails will be sent after encrypted by STARTTLS, and the SMTP port should be set as 25.
Note:
If you want to use STARTTLS, make sure that the protocol is supported by your e-mail server. If you
check the Enable STARTTLS checkbox when the protocol is not supported by your e-mail sever, your
e-mail will not be encrypted.
Authentication (optional): If your email server requires authentication, check this checkbox to use
authentication to log in to this server and input the login user name and password.
 For your privacy and to better protect your system against security risks, we strongly recommend
the use of strong passwords for all functions and network devices. The password should be
something of your own choosing (Using a minimum of 8 characters, including at least three of
the following categories: upper case letters, lower case letters, numbers, and special characters.)
in order to increase the security of your product.
 Proper configuration of all passwords and other security settings is the responsibility of the
installer and/or end-user.
Receiver: Input the receiver to which the email is sent.
Receiver's Address: The email address of user to be notified.
Note:
You can click
configured.
3. Click
Configuring HTTPS Settings
Purpose:
HTTPS provides authentication of the web site and associated web server that one is communicating
with, which protects against Man-in-the-middle attacks. Perform the following steps to set the port
number of https.
Example:
If you set the port number as 443 and the IP address is 192.168.1.64, you may access the device by
inputting https://192.168.1.64:443 via the web browser.
Note:
 For the camera that supports plug-in free live view, when you use HTTPS to visit the camera, you
should enable Websockets for live view. Go to Configuration > Network > Advanced Settings >
Network Service.
 HTTPS is enabled by default. The camera creates an unsigned certificate automatically. When you
visit the camera via HTTPS, the web browser will send a notification about the certificate issue.
Install a signed-certificate to the camera to cancel the notification.
Steps:
1. Enter the HTTPS settings interface.
Configuration > Network > Advanced Settings > HTTPS
2. Create the self-signed certificate or authorized certificate.
User Manual of PanoVu Series Network Camera
to check whether the setting is invalid after the required parameters are
to save the settings.
23