Table of Contents
Advertisement
Picture Name: Set the naming rule for captured picture files. You can choose Default in the
drop-down list to use the default rule, that is,
(e.g., 10.11.37.189_01_20150917094425492_FACE_DETECTION.jpg)
Or you can customize it by adding a Custom Prefix to the default naming rule.
5. Check the Upload Picture checkbox to enable the function.
Upload Picture: To enable uploading the captured picture to the FTP server.
Anonymous Access to the FTP Server (in which case the user name and password won't be
required.): Check the Anonymous checkbox to enable the anonymous access to the FTP server.
Note:
The anonymous access function must be supported by the FTP server.
6. Save the settings.
Configuring Email Settings
Purpose:
The system can be configured to send an Email notification to all designated receivers if an alarm event
is detected, e.g., motion detection event, video tampering, etc.
Before you start:
Configure the DNS Server settings under Configuration > Network > Basic Settings > TCP/IP before using
the Email function.
Steps:
1. Enter the Email settings interface:
Configuration> Network > Advanced Settings > Email
2. Configure the following settings:
Sender: The name of the email sender.
Sender's Address: The email address of the sender.
SMTP Server: The SMTP Server IP address or host name (e.g., smtp.263xmail.com).
SMTP Port: The SMTP port. The default TCP/IP port for SMTP is 25.
User Manual of PanoVu Series Network Camera
IP address_channel number_capture time_event type.jpg
Figure 2-12
Email Settings
22
Advertisement
Table of Contents
