HIKVISION DS-2DP1618ZIXS-DE User Manual page 109

 Configuring Time Synchronization by NTP Server
Steps:
(1) Check the radio button to enable the NTP function.
(2) Configure the following settings:
Server Address: IP address of NTP server.
NTP Port: Port of NTP server.
Interval: The time interval between the two synchronizing actions by NTP server. It can be set from
1 to 10080 minutes.
(3) You can click
Note:
If the camera is connected to a public network, you should use a NTP server that has a time
synchronization function, such as the server at the National Time Center (IP Address:
210.72.145.44). If the camera is set in a customized network, NTP software can be used to establish
a NTP server for time synchronization.
 Configuring Time Synchronization Manually
Steps:
(1) Check the Manual Time Sync radio button.
(2) Click to set the system time from the pop-up calendar.
(3) Click
Note:
User Manual of PanoVu Series Network Camera
Figure 7-2
Time Sync by NTP Server
Figure 7-3
to check whether the confguration is succeeded.
to save the settings.
Time Settings
102