Configuring Face Detection; Configuring Intrusion Detection - HIKVISION DS-2DE2A404IW-DE3/W User Manual

User Manual of Network PTZ Camera
detection. Refer to Section 5.2.1 Configuring Motion Detection.
6. Click
Notify Surveillance Center, Send Email, Trigger Alarm Output and Trigger Recording are
selectable. Refer to Section 5.2.1 Configuring Motion Detection.
7. Click

5.3.2 Configuring Face Detection

Purpose:
After the face detection is enabled, a face appears in the surveillance area, it will be detected and
certain actions may be triggered by the detection.
Steps:
1. Check the Enable Face Detection checkbox.
2. (Optional) You can check the Enable Dynamic Analysis for Face Detection checkbox if you
want the detected face get marked with rectangle in the live view.
3. Configure the sensitivity for face detection.
Sensitivity: Range [1-5]. The value of the sensitivity defines the size of the object which can
trigger the alarm, when the sensitivity is high, a very small object can trigger the alarm.
4. Click
schedule configuration is the same as the settings of the arming schedule for motion
detection. Refer to Section 5.2.1 Configuring Motion Detection.
5. Click
surveillance center, send email, upload to FTP, trigger channel, smart tracking and trigger
alarm output are selectable. Refer to Section 5.2.1 Configuring Motion Detection.
6. Click

5.3.3 Configuring Intrusion Detection

Intrusion detection can set an area in the surveillance scene and once the area is entered, a set
of alarm action is triggered.
Steps:
1. Enter the intrusion detection interface:
Configuration > Events > Smart Event >Intrusion Detection
© Hikvision
tab to select the linkage method taken for the audio input exception,
to save the settings.
Figure 5-21 Configuring Face Detection
tab to enter the arming schedule setting interface. The time
tab to select the linkage method taken for the video loss alarm, Notify
to save the settings.
50