Rapid Focus - HIKVISION DS-2DP1618ZIXS-DE User Manual

 Up to 12 calibration points are supported for each scene. At least 4 points should be configured.
More calibration points can increase the rate for successful calibration.
 Scatter the calibration points evenly in live view image for better calibration effect.
4. Save the settings.
Notes:
 In auto calibration mode, the more similar is the PTZ view and the panoramic view, the panorama
tracking gets more accurate.
 The more distant manual calibration sites are to each other, the panorama tracking gets more
accurate.

4.2.10 Rapid Focus

Purpose:
After this function is enabled, perform calibration and the focus can be quicker than quick focus.
Steps:
1. Enter the Position Settings interface:
Configuration > PTZ > Position Settings.
2. Check the Enable checkbox to enable the Rapid Focus.
3. Drag the red line on the live view image to the calibration position according to the user. You can
drag the ends of the red line to adjust the length of the line.
4. Click Start Calibration. There is the notice Calibrating on the live view image and the camera lens
performs auto focus.
5. After calibration, there is the notice Calibration succeeded on the live view image.
6. Click Save to save the settings.
7. You can repeat step 3 to step 6 to configure rapid focus for multiple scenes. Up to four scenes are
supported.
User Manual of PanoVu Series Network Camera
Calibration Parameters
Figure 4-21
60