HIKVISION DS-2DP1618ZIXS-DE User Manual page 93

Steps:
1. Enter the Object Removal Detection settings interface:
Configuration> Event > Smart Event> Object Removal Detection
2. Check the checkbox of Enable to enable the Object Removal Detection function.
3. The event triggered and park action related PTZ movement will be locked for 180 seconds after you
enter the unattended baggage detection interface. Optionally, you can click the
button to manually activate the movement, or lock the movement when the button turns to
4. Select the region from the dropdown list for detection settings.
5. Click the
6. Click on the live video to specify the four vertexes of the detection region, and right click to
complete drawing. Repeat the step to configure other regions. Up to 4 regions can be set. You can
click the button to clear all pre-defined regions.
7. Configure the parameters for each defense region separately.
Threshold Level: If you set the value as 5, alarm is triggered immediately after the object

entering the region.
Sensitivity Level: The value of the sensitivity defines the size of the object which can trigger

the alarm, when the sensitivity is high, a very small object can trigger the alarm.
8. Click
configuration is the same as the settings of the arming schedule for motion detection. Refer to
Section 6.1.1 Configuring Motion Detection for more details.
User Manual of PanoVu Series Network Camera
Figure 6-18 Configuring Object Removal Detection
by clicking it.
button to start the region drawing.
tab to enter the arming schedule setting interface. The time schedule
86