HIKVISION DS-2DP1618ZIXS-DE User Manual page 25

2. HTTP port, RTSP port and port of the camera.
Set the
 HTTP Port: The default port number is 80.

The default port number is 554.
RTSP Port:
 HTTPS
The default port number is 443.
Port:
 Server Port: The default port number is 8000.
Note:
When you use client software to visit the camera and you have changed the server port number,
you have to input the correct server port number in login interface to access to the camera.
 Enhanced SDK Service Port: The default server port number is 8443, and it can be changed to
any port number ranges from 2000 to 65535.
 WebSocket Port: The default port number is 7681.
 WebSockets Port: The default server port number is 7682.
Note:
WebSocket and WebSockets protocol are used for plug-in free live view. For detailed information,
see Network Service in Section2.2.2 Advanced Settings.
3. Click
Configuring NAT (Network Address Translation) Settings
Purpose:
Universal Plug and Play (UPnP™) is a networking architecture that provides compatibility among
networking equipment, software and other hardware devices. The UPnP protocol allows devices to
connect seamlessly and to simplify the implementation of networks in the house and corporate
environments.
With the function enabled, you don't need to configure the port mapping for each port, and the
camera is connected to the Wide Area Network via the router.
Steps:
1. Enter the NAT settings interface by
Configuration > Network > Basic Settings > NAT
2. Check the
3. Set the port mapping mode:
To port mapping with the default port numbers:
Choose
User Manual of PanoVu Series Network Camera
Port Settings
Figure 2-6
to save the settings.
checkbox to enable the UPnP™ function.
18