Configuring Region Entrance Detection - HIKVISION DS-2DP1618ZIXS-DE User Manual

selectable.
 Sensitivity: Range [1-100]. The value of the sensitivity defines the size of the object which can
trigger the alarm, when the sensitivity is high, a very small object can trigger the alarm.
 Detection Target: Set the detection target. You can select human, vehicle, or all (human &vehicle)
as the detection target from the dropdown list. For example, if Human is selected, only human
beings will be identified as detection objects.
7. Click
configuration is the same as the settings of the arming schedule for motion detection. Refer to Step 5
in Section 6.1.1 Configuring Motion Detection.
8. Click
Surveillance Center, Send Email, Upload to FTP/Memory Card/NAS, Trigger Alarm Output and Trigger
Recording are selectable. Refer to Step 3 in Section 6.1.1 Configuring Motion Detection.
9. Click

6.2.4 Configuring Region Entrance Detection

Purpose:
Region entrance detection function detects people, vehicle or other objects which enter a pre-defined
virtual region from the outside place, and some certain actions can be taken when the alarm is
triggered.
Steps:
1. Enter the Region Entrance Detection settings interface:
Configuration> Event > Smart Event> Region Entrance Detection
2. Check the checkbox of Enable to enable the Region Entrance Detection function.
3. Select the region from the dropdown list for detection settings.
4. Click the
User Manual of PanoVu Series Network Camera
tab to enter the arming schedule setting interface. The time schedule
tab to select the linkage method taken for the line crossing detection, Notify
to save the settings.
Configuring Region Entrance Detection
Figure 6-15
button to start the region drawing.
82