HIKVISION DS-2DP1618ZIXS-DE User Manual page 86

Note:
This function is only supported by certain camera models.
Steps:
1. Enter the audio exception detection interface:
Configuration > Event > Smart Event > Audio Exception Detection
2. Check the Audio Loss Detection checkbox to enable the audio input exception detection.
3. Check the Sudden Increase of Sound Intensity Detection checkbox to enable the sudden rise
detection.
 Sensitivity: Range [1-100], the smaller the value the more severe the sound change will trigger
the detection.
 Sound Intensity Threshold: Range [1-100], it can filter the sound in the environment, the louder
the environment sound, the higher the value should be. You can adjust it according to the actual
environment.
4. Check the Sudden Decrease of Sound Intensity Detection checkbox to enable the sudden drop
detection.
Sensitivity: Range [1-100], the smaller the value the more severe the sound change will trigger the
detection.
5. Click
configuration is the same as the settings of the arming schedule for motion detection. Refer to Step
5 in Section 6.1.1 Configuring Motion Detection.
6. Click
Notify Surveillance Center, Trigger Alarm Output, and Trigger Recording are selectable. Refer to
Step 3 in Section 6.1.1 Configuring Motion Detection.
7. Click
User Manual of PanoVu Series Network Camera
Audio Exception Detection
Figure 6-12
tab to enter the arming schedule setting interface. The time schedule
tab to select the linkage method taken for the video loss alarm. Send Email,
to save the settings.
79