The Dsp Control (Dsp Ctl) Page - Kurzweil K2700 Musician's Manual

Program Edit Mode

The DSP Control (DSP CTL) Page

The DSP Control (DSP CTL) Page
Use the DSP Control page to make coarse or fine adjustments to parameters of each DSP
block in the algorithm, and to adjust parameters for hard-wired modulation sources.
Function-parameter
The left-hand column of the DSP CTL page shows each function-parameter of the current
layer's algorithm. You can coarsely adjust the selected function-parameter in these left-hand
fields.
The function-parameters are listed along the left-hand side of the DSP CTL page and the
DSP MOD page. The label of each function-parameter depends on its function in the
current program's algorithm. For example, the Pitch function's function-parameter is labeled
Pitch; and the two-block Lopass function's function-parameters are labeled LP Frq and LP
Res.
Use each function-parameter to make coarse adjustments to each DSP function. Depending
on the parameter, values may be set in semitones (ST), cents (ct), decibels (dB) or Hertz (hz).
These adjustments are also combined with any modulation applied to each DSP function on
the DSP CTL and DSP MOD pages.
3-58