Kurzweil K2700 Musician's Manual page 100

In the Wiring Alg Editor, each function block has three editable parameters: number of
inputs, number of outputs, and block size. (The Output Mode parameter applies to the
entire algorithm.)
To select a block for editing, move the cursor down the display until no parameter field is
highlighted; then, using the < and > buttons, highlight a block to edit. Press the ^ button to
move the cursor back into the parameter fields, and then select a parameter to edit.
To edit the wiring signal path, select either an input of a block or an output of the entire
algorithm. By scrolling with Alpha Wheel or the Previous- and Next+ buttons, you can see
every possible wiring configuration for that selected signal path.
Inputs
Use the Inputs parameter to select the number of inputs for the currently selected DSP
block.
Num Blocks
Use the Num Blocks parameter to select the number of blocks for the currently selected DSP
block.
Outputs
Use the Outputs parameter to select the number of outputs for the currently selected DSP
block.
Output Mode
The Output Mode parameter determines the number of outputs from the algorithm.
With Output Mode set to Normal, the algorithm has one output.
With Output Mode set to Sep. L/R, the algorithm has two outputs, each of which is sent to
a separate stereo channel. The top output is the left channel, the bottom output is the right
channel. The output of any DSP block in the algorithm, as well as any of the inputs to the
algorithm, can be connected to either of the separate left/right outputs of the algorithm.
Note: When the Alt Input parameter is set to a layer in which Output Mode is set to Sep.
L/R, only the left channel of the stereo signal is used by the receiving layer.
Program Edit Mode
The Wiring Algorithm (ALG) Page
3-57