Kurzweil K2700 Musician's Manual page 20

USB Ports
Use the USB ports to connect the K2700 to a computer or USB hard drive in order to do the
following:
• Stream stereo audio between the K2700 and a DAW running on a computer.
• Use the K2700 as a MIDI controller to play software instruments on a computer/
tablet.
• Play and control the K2700 with a USB MIDI controller
• Use a computer/tablet to sequence multi-channel MIDI songs on the K2700.
• Backup and restore User Programs and Multis on a USB hard drive.
• Update the software and sounds of the K2700.
LCD Knob
Use the LCD knob to control the display brightness.
SW1 (SUSTAIN) and SW2 Jacks
Use the SW1 (SUSTAIN) and SW2 jacks to connect switch pedals. One switch pedal is
included with the K2700.
In Program Mode, SW1 (SUSTAIN) defaults to controlling Sustain, and SW2 defaults to
controlling Sostenuto. (For KB3 Organ Programs, SW1 (SUSTAIN) defaults to controlling
the Rotary Speaker speed, changing between fast and slow. This assignment can be changed
in Global Mode. The LCD display shows "KB3" when a KB3 Program is selected.)
In Multi Mode, pedal assignments can vary per Multi. Pedal assignments can be adjusted for
each Zone by using Multi Edit Mode.
Global Mode can be used to set pedal overrides, which can change the pedal assignments for
all Programs and Multis.
Note: Switch pedals must be plugged in before powering on the K2700. Do not to step on
the switch pedals when powering on the K2700, as the state of the pedals is detected as part
of the start up sequence.
Getting Started
The Rear Panel
1-11