Kurzweil K2700 Musician's Manual page 143

Program Edit Mode
FM Layer Page
Modwheel LFO->Amp
The Modwheel LFO->Amp parameter allows you to use the Modwheel or other physical
controller to control the amplitude modulation depth of the FM LFO for all FM Operators
in the layer.
When the Modwheel is set to its minimum value, amplitude modulation depth is
determined by the Amp Mod Depth parameter. When the Modwheel is set to its maximum
value, amplitude modulation depth equals the value of the Amp Mod Depth parameter plus
the value of the Modwheel LFO->Amp parameter.
Modwheel values between the minimum and maximum will scale the amount of modulation
between the value of the Amp Mod Depth parameter and the value of the Amp Mod Depth
parameter plus the value of the Modwheel LFO->Amp parameter.
Modwheel LFO->Amp can be set to values from 0-99, where 0 applies no amplitude
modulation, 1 applies the least amplitude modulation, and 99 applies the most amplitude
modulation.
The Modwheel LFO->Amp parameter works in combination with each Operator's AM
Sensitivity parameter on the FM Operator Page. To apply amplitude modulation to an
Operator, the FM Operator's AM Sensitivity parameter must be set to a value greater than 0
on the FM Operator Page.
To use a physical controller other than the Modwheel, go to the Parameters page, select the
FM Mod parameter, then select a different physical controller using the Control column.
Pressure LFO->Amp
The Pressure LFO->Amp parameter allows you to use keyboard pressure (aftertouch) to
control the amplitude modulation depth of the FM LFO for all FM Operators in the layer.
When keyboard pressure is at its minimum value, amplitude modulation depth is determined
by the Amp Mod Depth parameter. When keyboard pressure is at its maximum value,
amplitude modulation depth equals the value of the Amp Mod Depth parameter plus the
value of the Pressure LFO->Amp parameter.
Pressure values between the minimum and maximum will scale the amount of modulation
between the value of the Amp Mod Depth parameter and the value of the Amp Mod Depth
parameter plus the value of the Pressure LFO->Amp parameter.
Pressure LFO->Amp can be set to values from 0-99, where 0 applies no amplitude
modulation, 1 applies the least amplitude modulation, and 99 applies the most amplitude
modulation.
The Pressure LFO->Amp parameter works in combination with each Operator's AM
Sensitivity parameter on the FM Operator Page. To apply amplitude modulation to an
Operator, the FM Operator's AM Sensitivity parameter must be set to a value greater than 0
on the FM Operator Page.
3-100