Rear Panel AUDIO IN Jacks
The rear panel AUDIO IN LEFT and RIGHT jacks each accept either a 1/4" "phone plug"
in the center hole, or a 3-pin "XLR" male plug in the outer ring, and can accept signals at
line, instrument, or microphone levels. An internal switch detects which kind of plug is used
and automatically selects the appropriate preamp.
Input Source Examples
The K2700 AUDIO IN jacks can adapt to a variety of signal sources and types. See below for
details on setting the front panel AUDIO INTERFACE section controls appropriately.
For each signal type below, use the rear panel AUDIO IN Jack Type and Cable/Plug Type
listed in the right column, and set the AUDIO INTERFACE section controls listed in the
left column to the settings in right column. Finally, use the GAIN knobs in combination
with the Signal Level LEDs to set an optimal level for the input signal.
Line Level Unbalanced Signals
For use with an MP3 player, smartphone, keyboard, mixer, other consumer-grade audio
equipment:
AUDIO IN Jack Type
Cable/Plug Type
Hi-Z On Button
+48V On Button (Phantom Power) Disabled (LED Off)
Line Level Balanced Signals
For use with a pro keyboard, pro mixer, other line-level balanced source:
AUDIO IN Jack Type
Cable/Plug Type
Hi-Z On Button
+48V On Button (Phantom Power) Disabled (LED Off)
Rear Panel AUDIO IN Jacks
1/4"
1/4" Unbalanced Phone Plug (T-S)
Disabled (taller)
1/4"
1/4" Balanced Phone Plug (T-R-S)
Disabled (taller)
Audio Interface
C-3