Kurzweil K2700 Musician's Manual page 33

KB3 Program Controller Assignments
In each of the Factory KB3 Organ Programs, each Slider and Button in the front panel
CONTROL section will perform the assignments labeled below the Sliders, and Knobs 1-4
are typically assigned to EQ. The Display shows "KB3" when a KB3 Program is selected.
When a controller is moved, the name of the current assignment is shown in the Display.
Controller assignments can be adjusted in Program Edit Mode.
TRANSPOSE Buttons
The TRANSPOSE buttons can be used to change the tuning of notes played on the K2700
keyboard in semitones (also known as half steps). This is a convenient way to change the key
of a song without learning to play it in a different key.
The current transpose amount is shown in the top line of the Display. Press both
TRANSPOSE buttons simultaneously to reset the transposition to 0.
The TRANSPOSE buttons also transpose MIDI notes sent to the USB and MIDI Out ports.
PITCH WHEEL
Use the PITCH WHEEL to perform pitch bends. The Bend Up and Bend Down amount
can be adjusted for each Program in Program Edit Mode.
MODULATION WHEEL
In Factory Programs, the MODULATION WHEEL button will typically control a vibrato
or an effect amount. The name and value of the current assignment is shown in the Display
when the wheel is moved. The assignment can be adjusted in Program Edit Mode.
VARIATION Button
In Factory Programs, the VARIATION button will typically modify the sound by adding an
orchestral string section or synth pad layer, or enabling an effect. The name of the current
assignment is shown in the Display when the button is pressed. The assignment can be
adjusted in Program Edit Mode.
Pads
In Factory Programs, the 16 Pads are typically assigned to play notes or chords. The Pads
can also be assigned to behave as switches to control Program parameters, or to mute steps
in Arpeggiator or CC Sequencer patterns. Pad assignments can be adjusted in Program Edit
Mode.
Program Mode
Controllers
2-5