Kurzweil K2700 Musician's Manual page 151

Program Edit Mode
FM Alt Input Page
MaxDpth
Use the MaxDpth parameter to set the maximum modulation depth of Source 2.
When a DepthCtl control source is at its maximum value, Source 2 will apply the amount of
modulation set by the MaxDpth parameter.
Keymap Level Parameters
Adjust
Use the Adjust parameter to set the output level of the Keymap.
Vel Track
Use the Vel Track parameter to modulate the amplitude of each note of the Keymap based on
the MIDI velocity of each note played.
Positive Vel Track values will progressively increase the amplitude for higher velocities.
For example, with a positive Vel Track value, playing a velocity of 0 causes no change in
amplitude, playing each velocity further above 0 increases the amplitude by the Vel Track
amount.
Key Track
Use the Key Track parameter to modulate the amplitude of each note of the Keymap based
on the MIDI note number of each note played.
Positive Key Track values will progressively increase amplitude for each note played above
middle C, and progressively decrease amplitude for notes played below middle C. For
example, with a positive Key Track value, playing middle C causes no change in amplitude,
playing each key further above middle C increases the amplitude by the Key Track amount,
and playing each key further below middle C decreases the amplitude by the Key Track
amount.
Negative Key Track values will progressively decrease amplitude for each note played above
middle C, and progressively increase amplitude for notes played below middle C. For
example, with a negative Key Track value, playing middle C causes no change in amplitude,
playing each key further above middle C decreases the amplitude by the Key Track amount,
and playing each key further below middle C increases the amplitude by the Key Track
amount.
Source 1
Use the Source 1 parameter to modulate the Keymap output level with a physical controller
or other control source.
3-108