Kurzweil K2700 Musician's Manual page 230

Output
Use the Out parameter to set the rear panel audio outputs used for each zone of the current
Multi. This parameter determines the output settings for the main program signal and insert
effects of each zone
A setting of Auto will make that zone output audio based on the settings for the program
used by that zone. Program output settings are set in the Program Editor using the Output
parameter on the FX page.
A setting of A will output Zone audio to the "A" Balanced Analog Outputs.
A setting of B will output Zone audio to the "B" Balanced Analog Outputs.
Channel
The Channel parameter determines the MIDI transmit and receive channel for the currently
selected Zone. You can set this parameter to any of the 16 MIDI channels (1-16).
You can assign different Zones to the same channel, but only one Program can be loaded in a
channel at a particular time. The Program loaded will be whichever program change message
is received last.
Bank Mode
The Bank Mode parameter determines the controller number used for transmitting MIDI
Bank change messages. When sending Bank change messages to external MIDI equipment,
you may have to adjust this setting depending on which controller numbers the equipment
responds to. Most equipment responds to controller numbers 0, 32, or both. The Kurzweil
K2600 responds to controller 32, but is limited to 100 programs per bank.
You can set this parameter to any of the following:
None
MIDI Bank change messages are disabled.
Ctl0
MIDI Bank change messages are sent with controller number 0.
Ctl32
MIDI Bank change messages are sent with controller number 32.
Ctl0/32
MIDI Bank change messages are sent with both controller numbers 0 and 32.
MIDI Bank change messages are sent with controller number 32. (K2600 Program
K2600
numbers 0-99.)
Multi Edit Mode
MAIN Page
7-7