Controls Page - Kurzweil K2700 Musician's Manual

CONTROLS Page

Use the Controls page to adjust controller settings for each Zone. The top right hand corner
of the display shows the currently selected Zone number. Use the CHANNEL/LAYER/
ZONE/TRACK buttons to select a Zone.
The K2700 has 2 types of controllers, switch controllers and continuous controllers. Each
type of controller has different parameters, see each section below for details.
Controlling Program Parameters from Multi Mode
To assign a Multi controller to a Program parameter, use the Destination field. In the
Destination list, destinations that are assigned to parameters for the Program of the current
Zone will show the Program Parameter name next to the Destination number. Select one of
these destinations to control an assigned Program parameter.
You can also select the Destination field, hold the ENTER button, then move the controller
that was assigned in Program Mode.
Switch Controllers
This section describes parameters for the following switch controllers:
• SW pedal jacks 1 and 2 (Up to 2 pedals per jack: Sw.Pedal 1a, 1b, 2a, 2b)
• VARIATION button
• ARP button (Arp On/Off)
• LATCH button (Arp Latch)
• CC SEQ button
• CONTROL buttons 1-9 (Switch 1 - Switch 9)
• Key1-Key12
• Pad1-Pad16
Multi Edit Mode
CONTROLS Page
7-13