Changing Power Steering Oil - Kubota RTV900 Operator's Manual

74 PERIODIC SERVICE
BChanging Power Steering Oil
To avoid personal injury:
A Be sure to stop the engine before changing the
oil.
A Allow engine to cool down sufficiently, oil can
be hot and can burn.
1. Park the vehicle on a flat surface and raise the cargo
bed.
2. To drain the used oil, remove the suction hose on the
gear pump.
3. Drain the oil completely into the oil pan.
4. After draining, reinstall suction hose.
5. Fill with the new oil up to the "H" mark of the oil tank.
(See "LUBRICANTS, FUEL AND COOLANT" in
"MAINTENANCE" section.)
6. Start the engine and then turn the steering wheel
toward the right and left several times (this motion
causes air in the hose to discharge).
7. Check to see if the oil level is between the "H" and "L"
marks on the oil tank.
Oil capacity
(1) Suction hose
(2) Gear pump
5.9 L (6.2 U.S.qts.)
(1) Power steering oil tank (H) "HIGH"
(L) "LOW"