Kubota RTV900 Operator's Manual page 32

12 OPERATING THE ENGINE
5. Push the speed control pedal down
about 1/2 way.
(1) Speed control pedal
6. Insert the key into the key switch and
turn it "ON".
( ) "OFF" (Engine-Stop)
( ) "ON" (Engine-Run)
(A) "INCREASE"
(B) "DECREASE"
( ) "GLOW" (Preheat)
( ) "START" (Engine-Start)
C Check Easy Checker(TM) Lamps:
1. When the key is turned "ON", lamps(2)(3) should
come on. If trouble should occur at any location while
the engine is running, the warning lamp corresponding
to that location comes on.
2. The parking brake warning lamp(1) comes on while
parking brake is applied and goes off when it is
released.
If the parking brake is released but the lamp stays on,
it means that the brake fluid may be low or the brake
system may be damaged. (See "Checking Brake Fluid
Level" in "DAILY CHECK" in "PERIODIC SERVICE"
section.)
3. The hydraulic outlet warning lamp(5) comes on while
hydraulic outlet lever is engaged "ON" and goes off
when disengaged "OFF" (if equipped).
(1) Parking brake / Brake fluid
(2) Electrical charge
(3) Engine oil pressure
(4) Glow plug
(5) Hydraulic outlet (if equipped)
(6) Hazard / Turn signal (if equipped)
A Daily checks with the Easy Checker(TM) only, are not
sufficient. Never fail to conduct daily checks carefully
by referring to "DAILY CHECK" in "PERIODIC
SERVICE" section.