Changing Hydraulic Lift Oil - Kubota RTV900 Operator's Manual

BChanging Hydraulic Lift Oil
[Hydraulic dumping system model]
To avoid personal injury:
A Be sure to stop the engine before changing the
oil.
A Allow engine to cool down sufficiently, oil can
be hot and can burn.
1. Park the vehicle on a firm, flat and level surface.
2. Raise the cargo bed and mount the safety support.
3. To drain the used oil, remove the drain plug and filling
plug and drain the oil completely into the oil pan.
4. After draining, reinstall the drain plug.
5. Fill with new KUBOTA SUPER UDT fluid up to the
upper notch on the dipstick.
(See "LUBRICANTS, FUEL AND COOLANT" in
"MAINTENANCE" section.)
How to check:
Wipe dipstick clean with a rag and screw it into filling
hole. Remove dipstick again to see if the oil level is
between the upper and lower notch.
6. After filling, reinstall the filling plug.
Oil Capacity 8 L (8.5 U.S.qts.)
PERIODIC SERVICE
(1) Drain plug
(2) Filling plug with dipstick
(A) Oil level is acceptable within
this range
69