Checking Hydraulic Auxiliary Tank Oil Level; Cleaning Oil Cooler Net - Kubota RTV900 Operator's Manual

50 PERIODIC SERVICE
BChecking Hydraulic Auxiliary Tank Oil
Level
[Hydraulic utility valve equipped model]
1. Park the vehicle on a firm, flat and level surface.
2. Raise the cargo bed and mount the safety support.
(See "HOW TO RAISE THE CARGO BED" in
"PERIODIC SERVICE" section.)
3. To check the oil level, draw out the dipstick, wipe it
clean, replace it, and draw it out again. Check to see
that the oil level lies between the range.
If the level is too low, add new oil to the prescribed
level at the filling plug.
(See "LUBRICANTS, FUEL AND COOLANT" in
"MAINTENANCE" section.)
(1) Filling plug (A) Oil level is acceptable within this range
(2) Dipstick
BCleaning Oil Cooler Net
[Hydraulic utility valve equipped model]
To avoid personal injury:
A Allow oil cooler or oil line parts to cool down
sufficiently, they can be hot and can cause
injury.
1. Park the vehicle on a flat surface, lower the cargo bed,
shut off the engine and turn the key to the "OFF"
position.
If the key switch is "ON", the oil cooler fan may start to
rotate suddenly.
2. Take off the oil cooler net from the lower side and
remove all trash.
(1) Oil cooler net