Replacing Radiator Hose (Water Pipes); Replacing Power Steering Hose; Replacing Fuel Hose; Replacing Engine Breather Hose - Kubota RTV900 Operator's Manual

Hide thumbs Also See for RTV900:
Table of Contents

Advertisement

A When the coolant level drops due to evaporation, add
water only to keep the antifreeze mixing ratio less than
50%. In case of leakage, add antifreeze and water in
the specified mixing ratio before filling into the radiator.
BReplacing Radiator Hose (Water pipes)
Replace the hoses and clamps.
(See "Checking Radiator Hose and Clamp" in "EVERY
200 HOURS" in "PERIODIC SERVICE" section.)
BReplacing Power Steering Hose
Consult your local KUBOTA Dealer for this service.
BReplacing Fuel Hose
Consult your local KUBOTA Dealer for this service.
BReplacing Engine Breather Hose
Consult your local KUBOTA Dealer for this service.
BReplacing Brake Master Cylinder (Inner
Parts)
Consult your local KUBOTA Dealer for this service.
BReplacing Front Brake Seal
Consult your local KUBOTA Dealer for this service.
BReplacing Rear Brake Cylinder Seal
Consult your local KUBOTA Dealer for this service.
BReplacing Intake Air Line
Consult your local KUBOTA Dealer for this service.
BReplacing Remote Hydraulic Hose
Consult your local KUBOTA Dealer for this service.

EVERY 4 YEARS

BReplacing Brake Hose
Consult your local KUBOTA Dealer for this service.

SERVICE AS REQUIRED

BBleeding Fuel System
Air must be removed:
1. When the fuel filter or lines are removed.
2. When tank is completely empty.
3. After the vehicle has not been used for a long period
of time.
C Bleeding procedure is as follows:
1. Fill the fuel tank with fuel.
2. Start the engine and run for about 30 seconds, and
then stop the engine.
BReplacing Fuse
The vehicle electrical system is protected from potential
damage by fuses.
A blown fuse indicates that there is an overload or short
somewhere in the electrical system.
If any of the fuses should blow, replace with a new one of
the same capacity.
A Before replacing a blown fuse, determine why the fuse
blew and make any necessary repairs. Failure to
follow this procedure may result in serious damage to
the vehicle electrical system. Consult your local
KUBOTA Dealer for specific information dealing with
electrical problems.
C Replacement procedure
1. Disconnect the negative cable of the battery.
2. Remove the cover and the fuse box cover.
3. Pull out the blown fuse using FUSE PULLER in the
fuse box.
4. Insert a new fuse into the fuse box.
5. Install the fuse box cover and the cover.
6. Connect the negative battery cable.
PERIODIC SERVICE
81

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents