Removing Et 200Eco Pn - Siemens SIMATIC Distributed I/O ET 200eco PN Operating Instructions Manual

Replacing labels
1. Push the screwdriver into the small opening of the label at an angle and then lever it out.
Figure 2-7 Removing labels
2. Push the new label into the holder on the device.
2.6

Removing ET 200eco PN

Procedure
The ET 200eco PN is wired up and operating.
1. Switch off the supply voltage to the ET 200eco PN.
2. Disconnect the wiring from the I/O device.
3. Remove the fixing screws from the I/O device.
NOTE
Observe the information in chapter Looping PROFINET and the supply voltage (Page 61)
when replacing the I/O device.
ET 200eco PN
Operating Instructions, 06/2022, A5E01250250-AN
Installing
2.6 Removing ET 200eco PN
27