Zepro ZN 2500-130 Installation Instruction page 31

Installation
4.4.2 Adjusting the downward
tilt angle
NOTE!
The tilt angle must be set at 90° to the vehicle body
before the downward tilt angle is adjusted (see pre-
vious page).
m
WARNING!
To ensure that the lift is safe and CE compliant, the
downward tilt angle must be adjusted to max. 10°
if there are going to be people on the platform.
1. Raise the lift to the vehicle floor.
2. Loosen the lock screw of the end stop (2). Screw
the end stop all the way back towards the platform
(3). Image 48.
3. Tilt the platform down to max. 10° below the hori-
zontal. Image 47.
4. Adjust the end stop all the way to the top of the
cylinder (4). Image 48.
5. Tighten the lock screw in the end stop (5). See
Image 48.
The tightening torque for lock screws is between 3-5 Nm
Test all functions.
www.zepro.com
Adjusting collar
Lock screw
Bolt
Washer
Image 49. Tilt cylinder
Image 47. The tilt angle must be ad-
justed to max.10° down
2
5
3
4
Image 48. End stop with lock screw
End stop
ZN 2500-130/150
31