Table of Contents
Advertisement
Installation
7. The support frame should be positioned as high as possible within the specified C dimension. Adjust the
frame to the ideal height under the chassis. A car jack is useful. If necessary you can adjust the height of the
bracket by installing its upper and lower parts in an alternative
the chassis brackets" on page 15.
8. Fit the support frame to the trailer chassis using the clamps. See illustration below. Tighten the bolts us-
ing a torque wrench. Tightening torque: 180 Nm.
NOTE!
Welding is not permitted on the chassis brackets.
Do not move the lift all the way to the armstops or with the platform fitted before all the bolts are fully tight-
ened against the chassis.
Do not place the lift under load until all bolts are tightened.
9. Remove the mounting jig.
m
WARNING!
The friction plates are an important part of the underrun protection and must therefore always be installed between the brackets
and the vehicle's chassis beams.
Image 28. Fit the support frame to the trailer chassis using the clamps
www.zepro.com
If necessary adjust the angle of the arms by carefully operating the lift.
pattern of holes. See section "3.7 Adjusting
ZN 2500-130/150
23
Advertisement
Table of Contents
