Table of Contents
Advertisement
Before installation
3.7
Adjusting the chassis brackets
The chassis brackets can be set to two different heights. This affects the distance between the lift frame and
the chassis (202 mm/242 mm). Take this into account when calculating the C dimension. The brackets must
also be fitted differently depending on the chassis width, see the description below.
3.7.1
Adjustment
1. Undo the 8 bolts and nuts holding the two parts of the bracket together, see illustration below.
2. Fit the two parts of the brackets in the correct position with the eight bolts and nuts.
NOTE!
If the chassis width is 1300 mm or more, fit the lower part to the inside (B) of the upper part, see illustration
below. If the chassis is narrower than 1300 mm, fit the lower part to the outside (A) of the upper part, see
illustration below.
3.
Tighten the bolts using a torque wrench. Tightening torque: 180 Nm.
m
WARNING!
The parts must always be installed with eight screws – two in the front row of holes and three each in the middle and rear rows
of holes.
A
www.zepro.com
Position 1
B
Image 16. Adjusting the chassis brackets
Chassis width
ZN 2500-130/150
Position 2
B
A
15
Advertisement
Table of Contents
