Zepro ZN 2500-130 Installation Instruction page 29

Installation
4. Turn the adjusting collar so that the tilt cylinder aligns
with the attachment on the platform. See Image 43.
5. Loosen the three lock screws on the other tilt
cylinder, see Image 43
6. Turn the adjusting collar so that the tilt cylinder aligns
with the attachment on the platform. See Image 44.
m
WARNING!
The max. length of both cylinders must be adjusted
equally to avoid unwanted breakout forces.
7. Fit the other tilt cylinder to the platform mount-
ing. Use the supplied shaft and support wheel.
NOTE!
Make sure the cylinders are installed with the grease
nipples facing up.
8. Tighten the bolts using a torque wrench.
Tightening torque: 80 Nm.
9. Adjust the two cylinders alternately so that the
platform meets the vehicle body, see Image 42 (B).
10. Tighten the lock screws of the adjusting collar us-
ing a torque wrench. Tightening torque: 3-5 Nm.
www.zepro.com
Image 42. Adjusting the fit with the vehicle body.
Out
In
Image 43. Adjusting the tilt angle
Image 44. Fitting the tilt cylinder to the platform
ZN 2500-130/150
Lock screws, 3 pcs.
29