Powering Up The Tail Lift - Zepro ZN 2500-130 Installation Instruction

Powering up the tail lift
7

Powering up the tail lift

1. If applicable, ensure that the main switch is in the "Off" position.
2. If applicable, ensure that the cab switch (CS) is in the "Off" position.
3. When using a fuse box, connect the cable (1) to the battery's positive terminal and to the fuse box and
place the fuse (2) above, see Image 79.
4. When connecting directly to the positive battery terminal, place the fuse (2) on the positive terminal, see
Image 80.
5. Connect the main power cable (3) to the fuse box / positive terminal, see Image 79 - Image 80.
6. Screw tight the cable connections and fuse with the knob (4). Install the cables at 90° or 180° from each
other. Install the fuse at right angles to the cables; see Image 79 - Image 80.
IMPORTANT!
The knob must bear against and centre the cable lug so that it does not come into contact with the screw. Incorrect installation
can cause the fuse to be ineffective. Risk of fire in the event of a short circuit.
7. Install the fuse box cover.
8. Where fitted, set the main switch to the ON position.
9. Where fitted, set the cab switch to the ON position.
Image 79. Connection to the fuse box
Image 81. Correct installation
www.zepro.com
4
3
2
1
Image 82. Incorrect installation
4
3
2
Image 80. Connection to the bat-
tery's positive terminal
Image 83. Cover, fuse box
ZN 2500-130/150
53