Yardworks 060-1314-4 Manual page 51

model no.
060-1314-4
9. Unscrew the three M8 bolts of the
friction disc assembly to discard the
worn friction wheel rubber ring and
replace with a new one. Use 3 new
self-locking nuts to assemble a new
rubber ring, do not over tighten.
10. Clean the aluminum friction disc by
wiping down with a clean cloth and
follow the previous steps in reverse
order to reassemble the parts.
RePlACe SHIfT fORK STeeRING ASSeMbly
If the snowblower speed control will not move even with the engine on, check these two
cables, whether the center bolts are too tight found in 'Adjusting Self-Drive Speed Control
Handle Cables' section. If so, loosen the cables slightly by unthreading the center nut. If the
adjustments do not correct the issues, considering replacing the gear shift fork assembly.
Make sure all fluids are removed and spark plug is disconnected.
Tools required:
10mm size wrench
–
To remove and replace your snowblower's shift fork assembly, proceed as follows:
1. See Repair or Replace Friction Disc
step 1-7, as the shift fork can only
be removed when the hex shaft is
removed.
2. Carefully pivot the snowblower up and
forward so that it rests on the auger
housing. Place a piece of cardboard
or moving blanket on the ground
before tipping forward. Make sure all
fluids are removed and spark plug is
disconnected.
3. Remove the Shift Fork Cover by
removing the 2 M6 × 16 screws which
secures it.
| contact us: 1.866.523.5218
51