50
model no.
060-1314-4
5. Carefully remove the M8 hex nut on
each side which secures the hex
shaft and chain gear shaft to the
snowblower frame. Use a 19mm or
adjustable wrench to hold the center of
the hex shaft and use a 12mm socket
to remove the nuts on each side.
7. Slide the speed adjusting handle to the
position 6 (fastest forward speed) and
slide out the hex shaft and chain gear
shaft.
| contact us: 1.866.523.5218
6. Carefully remove the M6 hex bolt on
each side which secures the bearings
to the snowblower frame. Use a
13mm socket to remove the nuts and
bearings on each side.
8. With the hex shaft removed, pulled
out the spring pin shown and slide the
disc off.