44
model no.
060-1314-4
2. Slip the old auger drive belt over the
auger drive pulley. If you are unable
to remove the belt in this step, please
disassemble the engine pulley in the
next step.
4. Carefully pivot the snowblower up and
forward so that it rests on the auger
housing. Place a piece of cardboard or
moving blanket on the ground before
tipping forward.
5. Remove the wheels by first removing
the wheel clip and then sliding the
wheels of the axles.
| contact us: 1.866.523.5218
3. Remove the engine pulley and washer.