Yardworks 060-1314-4 Manual page 48

48
model no.
060-1314-4
15. Turn the snowblower right side up.
With the belt properly placed on both
the front pulley and the auger drive
pulley, pull the auger idler pulley back
away from the belt and slip the belt
inside the pulley. You can pull the
recoil to rotate the pulley to help get it
seated.
17. Carefully pivot the snowblower up and forward so that it rests on the auger housing.
Place a piece of cardboard or moving blanket on the ground before tipping forward.
Reinstall the base frame cover.
18. Turn the snowblower right side up. Install the plastic belt cover using two M6 × 16
bolts set aside from an earlier step. Torque until snug. Do not overtighten or you risk
damaging the plastic belt cover.
19. Perform a drive test to confirm everything is in working order.
| contact us: 1.866.523.5218
16. Pull the auger control handle to ensure
the idler pulley is properly engaging
the belt. Under the belt cover area,
make sure the distance on both sides
between the guide and pulley is the
same.