Yardworks 060-1314-4 Manual page 34

34
model no.
060-1314-4
Tighten the cable and reduce the length of stage 1 to approximately what is shown above
visually. Do not reduce the length of stage 1 to almost none, there will be a risk of no
disengagement. Loosen the nut counterclockwise, then loosen the center bolt clockwise.
Test function. Tighten the nut clockwise against the long sleeve bolt.
If the snowblower fails to drive with the drive control engaged and performing the drive
control cable adjustment fails to correct the problem, the friction disc may need to be
replaced. See 'Repair or Replace Friction Disc'
If the friction disc is ok, then you should replace the cable.
If you find the wheel drives when the handle is not pressed, or when you press the handle
and the wheels do not drive or rotate, the cable is most likely frozen. You should replace
the cable or wait until it thaws out to test.
| contact us: 1.866.523.5218
Nut
Center Bolt