model no.
060-1314-4
6. Unhook the connector in the control
handle. You may have to move the
control handle to make these easier to
remove (3).
7. Squeeze and remove the strain relief
from the control handle side (4).
8. Perform the steps in reverse with the
new cable.
RePlACe AUGeR belT
Make sure all fluids are removed and spark plug is disconnected.
Tools required:
10mm size wrench.
–
13mm wrench.
–
To remove and replace your snowblower's auger belt, proceed as follows:
1. Remove the plastic belt cover on the
front of the engine by removing two
M6 × 16 bolts.
| contact us: 1.866.523.5218
43