Table of Contents
Advertisement
METERS, INDICATORS AND LAMPS
The operator compartment contains the main functional controls to
operate the lift truck in a safe and controlled manner. The meter panel
consists of three sections: Warning Lights, LCD (Liquid Crystal Display)
monitor and operation buttons.
N
C
F
R
E
1. LCD (Liquid Crystal Display)
2. Operation Buttons
3. Multipurpose Warning Light
4. Malfunction Indicator Light-Engine Check Warning (not used on
Diesel or Carburetor lift trucks)
5. Glow Plug Indicator Light (Diesel lift trucks)
6. Oil Pressure Warning Light
7. Charge Warning Light
8. Parking Brake Warning Light
9. Seat Belt Warning Light
10
:
25
H
F
10. Meter Display (see note below)
11. Water Temperature Gauge
12. Fuel Gauge (not applicable)
13. Transmission Position
METER DISPLAY NOTE:
• In place of the time, the date or hour meter may be displayed.
• While driving, this display changes to the speedometer when the
vehicle speed is approximately 4.0 km/h (2.5 mph) or higher.
• This display also indicates the inspection/service timing (if
programmed), malfunctions and warnings.
• The display time and date will be reset if the battery cable is
disconnected or the battery is replaced. If the display has been
reset, set the time and date again.
NOTE TO THE OPERATOR:
EFI lift trucks have a creep home feature that will reduce engine RPMs if
the coolant temperature remains near the "H" position, transmission oil
temperature is high or engine oil pressure is low. This indicates that the
lift truck should be serviced by your Local Authorized Dealer.
1.
LCD
When the ignition switch is in the ON position, backlighting makes
the displays clearly visible to the lift truck operator. It displays normal
operation, malfunction and adjustment data.
2.
OPERATION BUTTONS
Use these buttons to change the display, make settings and enter
passwords.
38
Hide quick links:
Advertisement
Table of Contents
