Automatic Transmission Fluid Level; Refilling Automatic Transmission Fluid - UniCarriers 1F1 Operator's Manual

AUTOMATIC TRANSMISSION FLUID LEVEL

1. Stop the engine after idling for about ten (10) minutes.
2. Open the top panel and check for leakage. Pull out the level gauge
and wipe down the tip of the gauge with a clean cloth.
3. Insert the level gauge to the limit and gently pull it out again.
4. Make sure that the fluid adhered to the tip of the gauge is not
extremely worn, discolored or contaminated by foreign substances.
Also check if the fluid level is within the proper range.
5. If fluid is insufficient, refill with the specified fluid so that the level
gauge reads the proper range.
!
CAUTION
• Do not operate the lift truck with insufficient automatic
transmission fluid, because the truck transmission could
stop operating.
• If the transmission fluid is extremely worn, discolored or
contains foreign substances, immediately report it the proper
authority or contact your Local Authorized Dealer.

REFILLING AUTOMATIC TRANSMISSION FLUID

Automatic transmission fluid can be added through the level gauge
hole. Checking the fluid level with the level gauge, pour OEM fluid into
the level gauge hole until the fluid level is in the proper range (refer to
page 128).
Proper
area
• Carefully add transmission fluid so as not to mix dust and
foreign substances in the fluid.
• Do not use any automatic transmission fluid other than those
specified by the OEM, it may cause a malfunction in the
torque converter. Not only deterioration in the performance
of the lift truck but could result in an accident.
97
!
CAUTION