Operational Procedures; Gasoline And Lpg Lift Truck Starting - UniCarriers 1F1 Operator's Manual

Hide thumbs Also See for 1F1:
Table of Contents

Advertisement

OPERATIONAL PROCEDURES

There are certain hazards that cannot be avoided solely by mechanical
means in the everyday use of lift trucks. Only the intelligence, good
sense, and care of the operator, along with proper maintenance, will
assure that the lift trucks are operated properly. It is important to have
trained, reliable personnel operating your lift trucks. If, at any time, the
operator finds that the lift truck is not performing properly, discontinue
operation of the lift truck and report the condition to your supervisor for
correction.
When operating the lift truck under severe climatic conditions make
sure that the lift truck is manufactured and approved as conforming to
the local specifications, laws and regulations.
Conditions such as:
• high temperature
• high altitudes
• in cold storage
• when handling explosives and combustibles
• in areas where the lift truck is apt to cause radio interference
Proper operation of this lift truck is the mast should be tilted back and
the forks should be raised approximately 200 mm (8 in) above the
ground. Steering the lift truck is easier with the forks leading. Always
look in the direction of travel.
Operate the lift truck from the operator's position after assuring
operation will not endanger the operator or any other person. Do not
operate a lift truck in hazardous areas. Make sure that the forks and/or
load have clearance to lower and do not "hang-up".
!
• Do not turn the ignition switch ON unless the selector lever
is in neutral.

GASOLINE AND LPG LIFT TRUCK STARTING

(INCLUDING DUAL FUEL)
!
• Do not breathe exhaust gases, they contain colorless and
odorless carbon monoxide. Carbon monoxide is a dangerous
gas and can cause unconsciousness or death.
• Do not run the engine in closed spaces or poorly ventilated
rooms such as a garage or refrigerator, etc.
• Inspect the condition of the LPG hose connections and
check for gas leaks from LPG hoses and pipes before
starting the engine.
• In the event of a LPG leak or some other malfunctions, close
the discharge valve immediately. Have the LPG system
checked by your Local Authorized Dealer.
• Ensure that the LPG cylinder (tank) bracket is in place and
latched.
NOTE:
This lift truck if equipped with an interlock system that will not let you
start the lift truck without the operator being in the seat with the seat
belt fastened.
67
WARNING
WARNING

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

1f2

Table of Contents

Save PDF