Seat Adjustment; Suspension Seat Operator's Weight Adjustment; Forward And Backward Control Lever; Backrest Inclination Adjustment - UniCarriers 1F1 Operator's Manual

SEAT ADJUSTMENT

SUSPENSION SEAT OPERATOR'S WEIGHT ADJUSTMENT

To adjust the suspension seat to
the operator's weight pull out the
handle and then pump it up or
down.

FORWARD AND BACKWARD CONTROL LEVER

The forward and backward control lever
is located on the front left side of the seat
when sitting in the operating position
facing the mast.
To adjust the seat position, pull up and
hold while sliding the seat to the desired
position. Release the lever to lock into
position.
!
WARNING
• Before adjusting the seat turn the ignition switch to the off
position and apply the parking brake.
• Adjusting the seat while the lift truck is in motion can cause
loss of control.

BACKREST INCLINATION ADJUSTMENT

To adjust the backrest to the
desired angle pull up and hold
the lever or strap on the left side
of the seat. Release the lever or
strap to lock the backrest into
position.
NOTE:
When opening the top panel you may need to tilt the backrest forward
depending on the situation.
!
• If adjusting the angle of the backrest when not in the
operator's seat hold the backrest by hand and do not make
hasty or rough adjustments as this may cause an injury,
for instance the back of the seat may bump against the
operator's face and body, or the operator's finger may get
caught between the backrest and the grip.
79
WARNING