12. Fuel Gauge; 13. Transmission Position - UniCarriers 1F1 Operator's Manual

12. FUEL GAUGE

Indicates the current fuel level
in levels 0 - 5. When level 5 is
indicated, the fuel tank is full.
When the indication reaches
level 0, the display begins to
blink, and the multipurpose
warning light illuminates to
inform the operator of the
nearly empty fuel tank. Add
fuel immediately.
NOTE:
• If the lift truck is Dual Fuel, the fuel meter will not work when the lift
truck is operated with LPG.
• When operating the lift truck with LPG, check from time to time to
be sure that the LPG level warning light is not lit and that the LPG
level alarm is not on.
• To check the remaining amount of LPG, use the fuel gauge on the
LPG Cylinder (tank).
• When operating the lift truck with LPG, if the LPG Cylinder (tank)
fuel is to low the lift truck will not start
Fuel Indication
E F
Full
E F
E F
E F
E F
+
Empty
E F

13. TRANSMISSION POSITION

Level
When the transmission position indicator displays the "F" position and
Level 5
the transmission has shifted, the display appears as shown here.
Level 4
Level 3
When the transmission position indicator displays the "N" position and
Level 2
the transmission has shifted, the display appears as shown here.
Level 1
Level 0
When the transmission position indicator displays the "R" position and
the transmission has shifted, the display appears as shown here.
When the selector lever is in the "F" or "R" position and the operator
is not seated on the operator's seat for three (3) seconds, the
transmission will shift to neutral when 1) the parking brake is engaged
or 2) the truck speed is below 3 km/h (1.8 mph) and the display blink as
shown here.
The truck may also be equipped with a Seat Belt Interlock option which
may shift the transmission into neutral if the seat belt is not latched.
Refer to page 82 for Seat Belt Interlock options.
Sit on the operator's seat, latch the seat belt and shift the selector lever
to the neutral (N) position. Disengage the parking brake if engaged, and
then shift the selector lever again to forward (F) or reverse (R) in order to
drive.
When there is an error in the selector lever signal, the display blinks.
Contact your Local Authorized Dealer for inspection.
44