Lumbar Adjustment; Swivel Seat; Seat Belt - UniCarriers 1F1 Operator's Manual

LUMBAR ADJUSTMENT

To expand the upper lumbar
turn the knob clockwise (refer
to L1 position). To expand the
lower lumbar turn the knob
counter-clockwise (refer to
L2 position). If the knob is in
the center position (refer to A
position) both the upper and
lower lumbar supports are in
the neutral position.

SWIVEL SEAT

To swivel the seat (will only swivel 20o
to right or left) lift and hold the seat
swivel handle located on the right
side of the seat and turn in the most
comfortable direction for the best
view in direction of travel. Release the
handle to lock into position.
!
WARNING
• Before adjusting the seat turn the ignition switch to the off
position and apply the parking brake.
• Adjusting the seat while the lift truck is in motion can cause
loss of control.
A
L1
L1
L2
L2
80

SEAT BELT

1. Holding the tongue pull out the
seat belt gently.
2. Wrap the lower part of the
hipbone with the seat belt as
tight as possible.
NOTE:
If the seat belt cannot be pulled out
because it is locked, loosen it once and pull it out once more.
3. Being careful not to twist the seat belt, insert the tongue into the
buckle until it "clicks". If the lift truck is equipped with the Seat Belt
Interlock option, the seat belt must be fastened to start the lift truck
(refer to page 82).
For unfastening the seat belt, press the button on the buckle and pull
the tongue out of it. While lightly holding the tongue, let the seat belt be
rewound gently.
NOTE:
When unfastening the seat belt, be sure to hold the tongue because the
tongue may be pulled rapidly together with the seat belt.
Tongue
Buckle