Installation Of Attachments; Ansi/Itsdf Standards For Lift Truck Clamp Attachments; In Case Of Tip-Over - UniCarriers 1F1 Operator's Manual

INSTALLATION OF ATTACHMENTS

! WARNING
• This lift truck has been designed for attachments (refer to
"Lift Truck Modifications" on page 4).
• Before installing hook-on attachments, be sure to read the
installation manual issued by the attachment manufacturer
to assure correct and proper installation. Contact your Local
Authorized Dealer for a revised data plate.
ANSI/ITSDF STANDARDS FOR LIFT TRUCK CLAMP
ATTACHMENTS
!
WARNING
• The ANSI/ITSDF Standards regarding lift truck mounted clamp
attachments took effect for lift trucks shipped on or after October 7,
2010. This current standard affects lift trucks equipped with a load
bearing clamp (paper roll clamp, carton clamp, etc.) and requires
the operator to perform two distinct motions before opening
(releasing) the clamp. For example, the operator must press a
button and then move a lever to release the load (refer to page 65).
• ANSI B56.1 Section 7.25 "Load-Handling Controls" can be
reviewed by visiting the ITSDF website at www.itsdf.org

IN CASE OF TIP-OVER

Lateral tip-over can occur if
truck is improperly operated.
Don't risk injury or death.
WARNING
Slow down before turning!
IN CASE
OF TIP-OVER
Follow these
DANGER
instructions:
!
1. The following precautions should be closely observed to ensure
safe operation of the lift truck as well as to prevent personal
injury.
2. Slow down before turning.
3. Always make sure your seat belt is securely fastened, and stay
seated while driving.
!
In case of tip-over the operator should:
4. Stay inside the lift truck if it starts to tip or falls off a dock or
ramp.
5. Lean away from the point of impact.
6. Hold on firmly to the steering wheel with both hands.
7. Brace your feet and keep yourself in side the operator compart-
ment.
8. Do not jump outside of the lift truck.
24
Buckle up belt
Stay in seat
Hold on to
Lean away steering wheel Brace feet
WARNING
DANGER
Don't jump!