Samson 3730 Series Mounting And Operating Instructions page 18

Markings on the device
Firmware revisions (Communication K)
K 1.01
Internal revisions
K 1.10
The FEATURE_SELECT parameter allows you to set whether an active diagnostic function is to be re-
ported by a GOOD_FUNCTION_CHECK or a BAD_FUNCTION_CHECK (u KH 8384-4).
K 1.11
• More trigger conditions in the data logger (u KH 8384-4).
• More additional functions (FEATURE_SELECT) (u KH 8384-4).
• The limits of the discrete valve position (POS_D_LIMIT_LOW, POS_D_LIMIT_UP) can now be defined
as required (u KH 8384-4).
K 1.12
Resetting the identification parameters resets all the parameters saved in the controller. The parameters
saved in the controller are, however, not reset when just the start-up parameters are reset
(u KH 8384-4).
K 1.13
Internal revisions
K 1.15
Feature of ID number adaptation according to PROFIBUS PA Profile 3.02 added. It allows a
Type 3785 Positioner (Profile 2.0 and Profile 3.0) to be directly replaced with a Type 3730-4 Position-
er in the compatibility mode (u KH 8384-4).
K 1.16
The function to suppress extended diagnostic messages allows messages for the PROFIBUS diagnosis
protocol to be suppressed. The messages are still included in the condensed state according to their
classification. The parameter to suppress the diagnostic messages exists in the following integrations:
DD: 2.2.007
TROVIS-VIEW: >3.60.005 (device module)
DTM: 1.3.0.1
K 1.17
The versions K 1.12 to K 1.16 do not save a set point received in acyclic data exchange as the valid
value for the fail-safe action 'Last valid set point is used'. In the affected modules for data exchange,
the polling for a valid set point has been changed to GOOD_NON_SPECIFIC.
K 2.00
Partial stroke test (PST) and full stroke test (FST) added
K 2.01
Internal revisions
K 2.02
Correction of cyclic communication of negative valve positions
2-4 EB 8384-4 EN