Diagnostic - Network Connection - Colortrac SmartLF Ci40 Service Manual

17.3.

DIAGNOSTIC - NETWORK CONNECTION

Ethernet Check List For Colortrac Scanner (using the menu button on the control panel).

Enter your company issued IP address into the scanner.

Enter the Data Port address. (Recommended value of "17237", unless company IT department
uses a different value).

Enter Command Port address. (Recommended value of "17236", unless company IT department
uses a different value).

Make sure the MAC address gives a unique address. (If reads only 'FF's, please contact
support@colortrac.com).
Ethernet Check List for Colortrac Software.

Install the Ethernet driver, latest version on the company website
(http://www.colortrac.com/support/support_downloads.htm).

Enter the same company issued IP address as in the scanner.

Enter the Data port value as entered in the scanner. (See table below for data info)

Enter the Command port value as entered in the scanner. (See table below for data info)

After entering all the information, shut down and re-open the software.
Make sure the software Ethernet settings are entered in all the Colortrac software/utilities in the same
way. Refer to the user manual for reference to using the software/utilities
For further Ethernet diagnostics, follow the chart on the following pages.
Port Settings
Recommended Value
17236
(or same as scanner)
17237
(or same as scanner)
ScanWorks / Utilities
Command Port
Data Port
Ci Scanner Service Manual
SmartLF all in one
Port 2
Port 1
CopySmart
Port 1
Port 2
Page 95